Synergy Manufacturing Transfer Case Skid Plate

The Synergy Manufacturing Transfer Case Skid Plate is designed specifically for Jeep Wrangler and Wrangler Unlimited models. Do not worry about these plates being up for the intended job. A plate may be light in weight, but it is produced from 3/16" crush resistant Grade 50 A-572 solid steel. The design allows the plate to maintain its strength and be highly crush resistant. Resistant to corrosion and made with a completely smooth skid surface.

This skid plate assembly is designed to be used as a complete assembly using none of the factory skid plates or cross member.

Note – Engine skid bracket assembly will contact the OEM front driveshaft at full bump if no front bump stop spacer is used. A minimum of 1.0” bumpstop spacer is recommended if retaining the OEM front driveshaft. No bumpstop spacing is required if using a typical 1310 or 1350 aftermarket front shaft.