JKS Adjustable Track Bar Rear

If you just installed your lift, and are still utilizing your factory Track bar, then now is the time to upgrade to a JKS Manufacturing Rear Adjustable Track bar. You can easily adjust the length to center the axle housing beneath the vehicle.

The JKS Adjustable Track bar will control the lateral axle position with precision and simplicity. The job of the Track bar is to control the lateral movement of the axle housing on coil equipped models. These will attach to the chassis and axle on the opposite side of the vehicle with flexible mounting points to accommodate suspension travel. When a lift gets installed, the axle housing is often forced out of alignment. This will cause stress on the related components, and will cause excessive wear and handling problems.

The JKS Track bar has a variable length design, allowing the driver to center the housing after ride height alterations. The ends of the track bar feature high performance bushings that can handle the demands of the most aggressive of trails, providing a smooth ride with low noise and vibration. 

This Track bar does require a lift from 0-6.0 inches to be effective. The vehicle must be equipped with a CV type driveshaft if installing the track bar on axle housing with angled relocation bracket. This is a bolt-on installation, and is not compatible on right hand drive vehicles.