SET YOUR VEHICLE
FREE SHIPPING ON ORDERS OVER $70!
Order Now, Pay Later
TALK TO A PARTS EXPERT
SPECIALS!
Browse By Category
- Auxiliary Lights
- Light Bars
- Fog/driving Lights
- Underhood/rock Lights
- 3rd Brake Light Solutions
- Back Up Lights
- Other Auxiliary Lighting
- Shop All
Results for
Filters:
Stock
Category
Brand
Rating
Price
Stock
Category
Brand
Rating
Price
OH NO!
We couldn't find any results
We couldn't find any results
Search Tips:
- Use different keywords
- Double check your spelling
- Start with something less specific - you can refine your search results later
- Try changing some of your filters below:
Search term:
Brian
Garage
BRIAN'S JEEP has an empty or private garage.
Reviews
Brian has reviewed 1 Product(s).
EVO NOLIMITS MANUAL SWAY BAR DISCONNECT
BRIAN'S JEEP 5 years ago
Hey everyone, This install was very straight forward and super simple. This kit also fits the JL electronic sway bar! Unplug the wire harness to sway bar and set aside. Now pop the hood and locate your main fuse box. Remove any fuses that include sway bar and Smartbar. Now that the wire harness is unplugged and has zero power, zip tie that harness out of the way. You'll never need it again. Remove the 3 bolts holding electronic actuator on the sway bar end link. Place the supplied washer inside the flat recessed section of the sway bar assembly. Align the EVO replacement part with the spring portion firm against the washer in the recessed area. Use the three bolts supplied and begin to tighten down. Once snug up, give them bolts a nice quarter turn. To disengage the sway bar. Make sure your vehicle is on level ground. Go ahead and give the new EVO a few twists clockwise until tightened up against the plate. Your sway bar should now be disconnected. If for any reason it's not, you can use a thicker washer/spacer in the recessed portion of the sway bar. This instruction was mentioned towards the beginning of this article. (I had zero issues with mine but read where one person needed use a thicker washer / spacer.) To engage the sway bar, spin the EVO counter clockwise where the knob is furthest from the plate. Make sure once again you are on level ground before doing this step. This part from EVO is a very simple, affordable solution to a poor design. Works on all JL & JK Wranglers that have the factory electronic sway bar disconnect. **You will be left with a service light for the sway bar. Use any approved programmer or tuner to disable the warning light. The hardware specifically in my pictures was not included as I chose this for aesthetic purposes only.**
EVO Manufacturing NoLimits Manual Sway Bar Disconnect
Questions
BRIAN'S JEEP has not asked any questions.
Answers
BRIAN'S JEEP has not answered any questions.
Images
BRIAN'S JEEP has not submitted any images.