Chris

Reviews

Chris has reviewed 4 Product(s).

Solid Light mount
jeeps2little 3 years ago
As mentioned in the other review, the plates are thick but light aluminum with several mounting options for lights on the plates. The replacement screws are stainless for a T30 bit.
---

---
Grimm Offroad A-Pillar Light Mount

Initial impressions are really good
jeeps2little 3 years ago
Much improved output over stock halogens. Not too happy about just shoving the controller down inside the headlight body but there is plenty of room, just no good way to secure them. Will check them in a month or so to see if they have rattled around and messed up the back of the reflectors. The instructions included are a bit vague but you can figure it out. You NEED to completely remove the set screw to be able to rotate the bulb itself. You are limited in rotation to the indexed holes in the plastic body but it worked out fine on my 2021 Sport S. It is possible to get them 180 degrees off and then your high beams and low beams are essentially backwards until you get the bulb portion rotated correctly. You HAVE to readjust your headlight aiming when you are done installing. They will likely be so far off that it is just silly. Take the 5 minutes and get them right. Super simple with a Philips screw driver, tape measure, masking tape and a wall/garage door.
---
Oracle LED Bulb Headlight Conversion Kit - Pair

Solid protection
jeeps2little 3 years ago
Very solid parts with good welds and finish. Install is straightforward and you don't need to put it on a lift to do this. A floor jack on the frame is more than enough to unload control arm and shock mount. Only need 18mm wrenches and 21mm wrenches to complete. Parts fit right on with only a little persuasion for one side to get the control arm hole to line up. Doesn't appear that there are sharp edges or plates to keep the skids from sliding over most anything.
---
Artec industries Rear LCA bolt-on skids

Easy install and way more coverage
jeeps2little 3 years ago
Just like the like the video says, 5 min install. Only tool you need is a 10mm wrench. Very straightforward and easy install. So much beefier and thorough protection than the oem part.
---
Rock Hard 4x4 Front Axle Disconnect FAD Skid Plate - Black

Questions

Answers

Images