SET YOUR VEHICLE
FREE SHIPPING ON ORDERS OVER $70 in the contiguous US lower 48 states
TALK TO A PARTS EXPERT
SPECIALS!
Customer Photos and Videos
5out of
5stars
TumbleWeed
I put these RCV's on my 2015 JKUR and loved them. Money spent on recovery gear or upgrades that prevent you from getting stranded due to failure is the best way to spend money for Jeep parts. Not to mention very little maintenance needed. If you are on the fence about going with CV's, let me nudge you a bit. Go get them!
5out of
5stars
Tak
Nice quality and fit perfectly on my JK. Not that hard to install with the videos on youtube. Very strong axles to handle my 38" tires without any issues. Much way better than stock shafts. Have them for a few years now and so far so good. Just make sure you grease them per the manual.
1 of 1 people found the following review helpful
5out of
5stars
Upgrade brakes
Nice to have the comfort of having them on. Had them on Rubicon trail with35s. Now have 37s
4out of
5stars
Joe
I just installed these on my 2010 JK. Great axles as everyone knows. HOWEVER, mine only came with 5 new bolts for the wheel bearings. Six are needed. Also, the threads for the axle nut are finer than the threads on the stock axle and new nuts are not provided. One trip to NAPA and the problem was solved with a couple M24x1.5 spindle nuts. We did find that shoving the axle into the orange boot by hand worked better than using a soft face hammer.
1 of 1 people found the following review helpful
4out of
5stars
Billy joe jim bob
Have had them for about a yr now, no real issues running on 37s with them. Only complaint is that the drive side axle clicks when turning when im in 4wd. Has done this from the start. Its quiet when normal driving.
Product images
Community Media