SET YOUR VEHICLE
FREE SHIPPING ON ORDERS OVER $70!
TALK TO A PARTS EXPERT
SPECIALS!
Customer Photos and Videos
5out of
5stars
Rosco
The installation was pretty easy, used Youtube to find the mounting bolt inside under a plastic cover. Then it was a quick disconnect and reconnect. Back up light is seriously improved over stock LED. You do need the little reflective disks mounted on the rear of your vehicle as they are not reflective. I stuck mine just above the bumper and you don't even see them. They are cheaper than one stock LED replacement.
5out of
5stars
JoeDoc359
I purchased these tail lights one year ago and am very pleased with them. The install was easy and did not take long. I immediate appreciated the brightness of the brake lights. These lights replaced a smoked lens trail light that I felt was too dim in the sunlight. The reverse lights are also great at providing plenty of light for backing up in the dark. A few months after installing, the passenger side light started getting moisture in it and began to not work properly. I was able to get it replaced free of charge except for shipping. Overall, these are great lights and well worth the price.
5out of
5stars
Ralph
These flush tail lights are a game changer. They are flush to the body of the Jeep and most importantly they are simple to install
5out of
5stars
Greg
I replaced the OEM LED taillights with these. The fit is great and it’s a quick easy install. I shouldn’t have waited for so long to make the switch.
5out of
5stars
Greg
These lights are easy to install and a great upgrade to the factory light.
1 of 1 people found the following review helpful
5out of
5stars
AdamOC
Replaced the OEM LED taillights in about 15 minutes. Even the salesmen at the dealership were surprised with how clean they looked. No more tail light bulge. Had one fail and ORACLE customer service was excellent, they shipped a new tail light right away.
1 of 1 people found the following review helpful
4out of
5stars
BluBear
While these are super easy to install and look amazing, if you have blind spot monitoring, be aware that these are going to make it run wonky. The BSM detectors in the stock Jeep tail light housings are angled outward just a bit, but in these, they are flat. I've noticed that detection is now spotty, and sometimes does not even detect a car. It's not a huge deal, but if Oracle had angled the detectors out just a little, I think BSM would have continued to work as well as stock. Is this a deal breaker? No. But it's something you should be aware of before you plunk down a big hunk of cash.
Product images
Community Media