SET YOUR VEHICLE
FREE SHIPPING ON ORDERS OVER $70 in the contiguous US lower 48 states
TALK TO A PARTS EXPERT
SPECIALS!
Customer Photos and Videos
5out of
5stars
BT
Especially handy with my pre wired aux in the Rubi.
5out of
5stars
Jon k
This is one of those things people overlook when installing their winch. It’s for safety and I I was skeptical about getting this product. I decided to get this because my wireless remote on my winch was activated by accident (not by me). If the other buttons were pushed, my winch could have destroyed my bumper. I have it installed to one of my factory auxiliary buttons. No more worries because there is no power to my winch without pushing my auxiliary botton. It’s super easy to install and should take no more than 45 minutes.
1 of 1 people found the following review helpful
5out of
5stars
ocabj
I hooked this up to act as a cut off for the winch. I didn't use the included physical switch and wired the solenoid using one of the terminals on an sPod Bantam. Was able to mount the solenoid on the battery tray barrier of the Jeep JK between the battery and the engine (battery side). If anything, my only complaint is that the boots for the wires to the solenoid don't really go on easily. Takes a lot of stretching and prying.
2 of 2 people found the following review helpful
5out of
5stars
Bad Luck Bill
Little challenging to find a good location to mount it. Overall its right what I wanted and for the piece of mind that if I am in an accident in the front that it has less of a chance to ground the power wire.
Product images
Community Media