SET YOUR VEHICLE
FREE SHIPPING ON ORDERS OVER $70 in the contiguous US lower 48 states
TALK TO A PARTS EXPERT
SPECIALS!
Customer Photos and Videos
4out of
5stars
JTR
I've had no issues with the lights, they've been on for about a month through some heavy rain. Beware, the tabs are not super robust and may crack if you overtighten the zip ties. Depending on your grille's spacing, they might require some up and down adjustment to line up correctly. Wiring was a breeze per the instructions.
4out of
5stars
Rocky Mtn Gladiator
Kit comes with the 3 lights, a wiring harness, t-taps and zip ties, everything you need is included in the box which is great. Install is pretty simple, I followed the steps in the Oracle & Northridge videos. Do the NorthRidge grill hack & cut off 4 of the grill clips when you remove your grill because chances are you are going to be taking your grill off pretty frequently once you have these installed. Couple of issues: 1. My wiring harness fell apart during install. I connected everything to test about 1/2 through, then disconnected the harness to route the wire and noticed one of the wires on the harness had detached from the connector. Wasn't a big deal, easy enough to pull the pin, open it up and solder back together but it makes me wonder how well this harness will hold up over time. TIP 1: Make sure you put some electrical tape on every connection. 2. One of the lights was either not sealed properly or damaged during shipping. I washed my truck after installing and one of the lights filled with moisture. I've put in a warranty claim with Oracle last night and already heard back from them. They have great customer service so I'm not that concerned. TIP 2: One of the guys on the forums put a little silicone sealant on the back of every light before installing them. He said it helped seal any possible cracks / leaks and acts as a little buffer to protect your grill. Ill do that when I swap them out. 3. Look closely at the lights while installing them, there is a top and bottom to the light but it is not labeled. Its easy to install one upside down if you are not careful. TIP 3: Make sure you have extra zip ties (more of a life rule than a tip) . 4. Wiring options: the Side marker lights that they tell you to connect to are not always on which means, these do not always stay illuminated. In the Forums, some people connect to a switch panel, some connect to an ignition source so they are always on, some connect to the DTRL circuit. I think I'll switch over to DTRL at some point or build a custom wiring harness to make them blink with my turn signals... Either way, make sure you understand the different options and how to wire them the way you want them.
4out of
5stars
Ralph
Overall these lights are really nice! I did have a bit of an issue keeping them on and connected. Once I figured out how to keep them together, they were perfect! Overall I would recommend to anyone!
Product images
Community Media