Eaton E-Locker Dana 44
TJ
Product Resources
Features & Product Details
The Eaton Dana 44 Elocker 4 30 Spline 3.92 and Up is an accessory that improves the traction that an automobile has. It locks the internal differential gear which in turn ensures that the vehicle is able to master a powerful capacity of operation. It is able to ensure 100% axle load support which ensures power relay is achieved effectively.
The Eaton Dana 44 Elocker 4 30 Spline 3.92 and Up is able to give an automobile greater strength in operation and works with the 30 Spline axles to give the relay system and power setting an enhanced performance. It utilizes axles that carry 3.92 and Up Gears and with this ensures the power from the engine is effectively converted to thrust. The Elocker is also instrumental in aiding an automobile gain maneuverability which not only aids a driver in control but also in the power generation and relay system.
Does not fit Jeep JK modelsSpecifications
PEOPLE WHO VIEWED THIS ITEM ALSO VIEWED
QUESTIONS & ANSWERS
-
Q: 06 rubicon front axle Jeep McJeepface3 years ago
Will this locker fit in a 2006 rubicon front axle? I will be regearing to 4.88 at the same time so will I need thick cut gears to make this work?
-
-
0 of
0 people found the
following answer helpful
A: This locker will work in your 06 Rubicon axle. You would use thin 4.88 gears with this locker. You would use a thick cut gear if you had the 3.73 and down locker, 19977-010.
Northridge Kaleb @ Northridge4x4 3 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Eaton e locker Beau4s3 years ago
-
-
0 of
0 people found the
following answer helpful
A: You are going to want this one. https://www.northridge4x4.com/part/lockers/19977-010-eaton-dana-44-elocker-30-spline-3-73-and-down
Northridge Chris @ Northridge4x4 3 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Eaton e Locker 3.92 and up hemi1run3 years ago
-
-
0 of
0 people found the
following answer helpful
A: Yes, but the gear set also plays a role in that. There are thick or thin cut gear sets. With this locker you would need to use the thin cut 4.88 gear set, like the Yukon YUKYGD44-488. If you have thick cut gears, then you would use the EAT19977-010 locker with the 4.88's.
Northridge Kaleb @ Northridge4x4 3 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful