Adams Driveshaft Extreme Duty Series Front and Rear Spicer Solid 1310 CV Driveshafts

QUESTIONS & ANSWERS

• Q: Adam's Driveshaft Extreme Duty  AJ4 years ago

  If I install these on my stock JKU axles will they still work later on when I upgrade axles?
• • 1 of 1 people found the following answer helpful

    A:  If you are upgrading but keeping Dana 44's they will work. You would need the upgraded axle to have the factory style flange. If you are upgrading to Dana 60's, then no, they will not work.

    Northridge Kaleb @ Northridge4x4 4 years ago  
    Yes  No
    Was this answer helpful?

• Q: ADAMS DRIVESHAFT EXTREME DUTY SERIES   VASH4 years ago

  Do these driveshafts work with automatic transmissions?
• • 1 of 1 people found the following answer helpful

    A:  Yes they do.

    Northridge Kaleb @ Northridge4x4 4 years ago  
    Yes  No
    Was this answer helpful?

• Q: Driveshaft 1310   aikitkd015 years ago

  Does this driveshaft will work with a standard manual transmission?
• • 3 of 3 people found the following answer helpful

    A:  Yes they will.

    Northridge Kaleb @ Northridge4x4 5 years ago  
    Yes  No
    Was this answer helpful?

• Q: adams 1310 driveshaft  Darrell5 years ago

  Does the extreme duty 1310 front and rear driveshafts come in one size fits all up to a 4.5 inch lift or would you need a measurement for a taller lift?
• • 5 of 5 people found the following answer helpful

    A:  They have enough slip built into the shaft to fit from 0-6" of lift.

    Northridge Kaleb @ Northridge4x4 5 years ago  
    Yes  No
    Was this answer helpful?