Revolution Gear D44 35 Spline Rear Axle Upgrade Kit without Locker
JK Non-Rubicon
Product Resources
Features & Product Details
Revolution Gear and Axle D44, 4140 Chromoly US Made 35 Spline Rear Axle Upgrade Kit without Locker. All Revolution Rear Axle Kits come with the Bearings seals and retainers 100 Percent pressed together and ready to install and are backed by a comprehensive lifetime warranty that covers all failures including bent shafts. Revolution Gear and Axle US Made axles utilize 4140 Chromoly for maximum strength and a lifetime of trouble-free performance. Our US Made axles are induction hardened with rolled splines.
Note: Wheel studs are included in this kit but are not installed into the axles for safer transport. Install studs using red Loctite and torque to 90Ft-LbsSpecifications
PEOPLE WHO VIEWED THIS ITEM ALSO VIEWED
QUESTIONS & ANSWERS
-
Q: PR60 Semi Float Rear Mark4 years ago
Will these fit a dynatrac prorock 60 semifloat rear with a 35 spline eaton locker?
-
-
0 of
0 people found the
following answer helpful
A: No they wont. These are for a Dana 44.
Northridge Kaleb @ Northridge4x4 4 years agoWas this answer helpful? -
0 of
0 people found the
following answer helpful
A: Depends. If you have a Pro Rock 60 for a JK, it will likely work. Shaft lengths and outer bearing dimensions are determined by the JK because the JK brakes, etc. have to fit. I called Dynatrac because I'm in a similar situation and that's basically what they told me.
SoCal Rock Lobster @Was this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Jeep jk Sport Arb Colorado Jeep5 years ago
-
-
1 of
1 people found the
following answer helpful
A: Yes they will.
Northridge Kaleb @ Northridge4x4 5 years agoWas this answer helpful?
-
1 of
1 people found the
following answer helpful