Currie Enterprises Johny Joint Track Bar w/ Bracket Rear

Currie Enterprises has developed their Johnny Joint Rear Track Bar to work in concert with the front track bar to greatly improve and stabilize the articulation in your vehicle. This kit includes the heavy duty trac arm relocation bracket that allows the trac arm to be installed at a proper angle and position for lifted vehicles which will improve handling by correcting the roll center geometry. 

These particular track bar bracket is a simple bolt on installation on the rear axle housing that will allow the user to adjust the pivot point to their liking. The brackets have been crafted from heavy duty steel, and the bar is made from 1 ¼” heavy wall 4130 chromoly tubing, and features the 2” Johnny Joint rod ends on each end.

It is preferred to see this kit employed in TJ Wrangler applications because the standard trac bar bracket will be angled towards the gas tank. This leaves little clearance. Therefore, the new Currie bracket has been designed with a proper angle to provide better clearance. For LJ applications, there is enough gas tank clearance, with that said the CE-9123 kit with the standard trac bar bracket will work just fine.