The Tera CRD60 HD Rear Coilover Full-Float Axle Assembly is designed as a direct bolt-on for the TeraFlex Coilover System and is available with pre-installed Super 60 gears, an ARB air locker and full-float axle shafts.
Engineered to integrate seamlessly with TeraFlex JK Coilover Kits, this axle is a true direct bolt-on solution. It features integrated Coilover Mount Brackets and bump-stop strike pads, to handle the increased loads and articulation of a TeraFlex/Falcon Coilover Suspension System.
Available with Super 60 ring & pinion gear ratios of 4.30, 4.88, or 5.38, this 70" wide axle bolts directly into all JK models equipped with a TeraFlex Coilover System—eliminating the fabrication and guesswork typically associated with axle upgrades.
Features:
Full-float rear axle design for maximum strength and durability
Designed specifically for TeraFlex JK Coilover suspension systems
Integrated Coilover Mount brackets
Bump-stop Strike Pad High-clearance Lower Control Arm brackets
Reinforced Upper Control Arm brackets Turn-key axle solution for Coilover-equipped JKs
Available with 4.30, 4.88, or 5.38 Super 60 gearing3.25" O.D. x 0.375" wall DOM axle tube for superior strength vs. weight
70" WMS-WMS and 8x6.5" wheel bolt pattern
Fixed spindle mount hub assembly
Tera CRD60 specific high-pinion rear axle housing design
Includes 1350 series pinion yoke35-spline inner and outer axle shafts
HD bearing caps increase rigidity and reduce ring & pinion distortion
Constant Radius Design (CRD) provides maximum ground clearance regardless of pinion angle
Built-in skimmer" cuts ring gear oil halo and forces it into the pinion bearings
Outer pinion bearing pocket features a renewable oil reservoir that sends cool oil to the pinion bearing
Oversized outer pinion bearing handles increased torque and high-load conditions
High-capacity housing holds maximum amount of oil
Pre-installed inner axle seals
Ductile cast iron housing w/ increased rib gussets
HD ductile iron differential cover w/ increased cover mounting area
Integrated lower control arm skid plates
High-flow oil passages
Reinforced rear track bar mount w/ multiple mounting locations
UV protected triple-stage powder coat for corrosion resistance1/4"-thick CNC laser cut axle brackets for extreme strength
Pre-installed upper control arm bushings
Proper pinion angle and raised track bar bracket for lifted JL applications
Pre-tapped hole on spring perch for bump stop extensions
Pre-drilled holes for limit straps and lower spring retainers
Retains all JT ESP, ABS, and speedometer sensor capability100% engineered, designed, and built in the USA w/ new components
Vehicle fitment info: All JK Wranglers with TeraFlex Coilover Suspensions 0-6" Lift
Specs:
WMS-WMS: 70"
Axle Tube: 3.25" x 0.375"
Wheel Bolt Pattern: 8x6.5"