The TERA60 HD Front Coilover W/Locking-Hub Axle Assembly is designed as a direct bolt-on for the TeraFlex Coilover System and is available with pre-installed Super 60 gears, an ARB air locker, HD Steering and Big Brake kit.
Engineered to integrate seamlessly with TeraFlex JK Coilover Kits, this axle is a true direct bolt-on solution. It features integrated Coilover Mount Brackets, bump-stop strike pads, high-clearance lower control arm brackets, and reinforced upper control arm mounts to handle the increased loads and articulation of a TeraFlex/Falcon Coilover Suspension System.
Available with Super 60 ring & pinion gear ratios of 4.30, 4.88, or 5.38, this 70" wide axle bolts directly into all JK models equipped with a TeraFlex Coilover System—eliminating the fabrication and guesswork typically associated with axle upgrades.
TERA60 HD Front axles also include HD Tie Rod and Drag Link, TeraFlex Big Brake kit, 35 spline axle shafts, sensors, TeraFlex HD wear adjustable Ball Joints and much more.
Features:
Coilover mount brackets
Bump stop strike pad brackets
3.25" O.D. x 0.375" wall DOM axle tube for superior strength vs. weight
70" WMS-WMS and 8x6.5" wheel bolt pattern
Includes Front Big Brake Kit w/ 13.3" Vented Rotors
Fixed spindle mount hub assemblyTera60 specific high-pinion front axle housing design
Includes 1350 series pinion yoke 35-spline inner and outer axle shafts
Outer pinion bearing pocket features a renewable oil reservoir that sends cool oil to the pinion bearing
Oversized outer pinion bearing handles increased torque and high-load conditions
High-capacity housing holds maximum amount of oil
Asymmetric housing design for extra-long tube side strength
Pre-installed inner axle seals
HD forged inner knuckles w/ greater upper and lower section strength
Ductile cast iron housing w/ increased rib gussets
HD ductile iron differential cover
Smooth radius bottom design to glide over rocks and obstacles
Integrated lower control arm skid plates
High-flow oil passages
Reinforced front track bar mount (ties into spring pad) for greater strength
UV protected triple-stage powder coat for corrosion resistance
1/4"-thick CNC laser cut axle brackets for extreme strength
Integrating the front upper control arm mounts into the housing increases up travel an additional 2" compared to other aftermarket Dana 60 axles
Pre-installed upper control arm bushings
Proper pinion angle for lifted JK applications
4-6" Lift features a raised pinion angle and raised track bar bracket (where applicable)
Pre-tapped hole on spring perch for bump stop extensions
Pre-drilled holes for limit straps and lower spring retainers
Retains all JK ESP, ABS, and speedometer sensor capability
100% engineered, designed, and built in the USA w/ new components
Vehicle fitment info: All JK Wranglers with TeraFlex Coilover Suspensions4-6" Lift
Specs:
WMS-WMS: 70"
Axle Tube: 3.25" x 0.375"
Wheel Bolt Pattern: 8x6.5"