- Suspension
- Exterior
- Drivetrain
- Lighting
- Interior
- Recovery
- Engine/Underhood
- Lifestyle
- Wheels & Tires
- Set Your Vehicle
- Bumpers
- Front Bumpers
- Front Bumper Accessories
- Rear Bumpers
- Rear Bumper Accessories
- Winch Plates
- Vacuum Pump Relocation
- Shop All
- Auxiliary Lights
- Light Bars
- Fog/driving Lights
- Underhood/rock Lights
- 3rd Brake Light Solutions
- Back Up Lights
- Other Auxiliary Lighting
- Shop All
Category
Brand
Rating
Price
Category
Brand
Rating
Price
We couldn't find any results
- Use different keywords
- Double check your spelling
- Start with something less specific - you can refine your search results later
- Try changing some of your filters below:
Search term:
- Exterior
- Bumpers
- Rear Bumpers >Smittybilt XRC Bumper w/Hitch Black - JK
Smittybilt XRC Bumper w/Hitch Black
JK
Features & Product Details
Smittybilt XRC Rear Bumper w/Hitch is manufactured from 3/16th cold rolled steel with hard mount D-Rings welded inside and outside. Each weld is grounded down and smooth out for a refined finish. It features a high degree approach angle with raised corners that maximize the overall ground clearance. The Smittybilt XRC Rear Bumper w/Hitch is a one-piece welded unit with the solid plate middle section that wraps the frame horns and the lower cross member for added security. The included 2-inch receiver hitch features two D-Ring mounts without the d-rings. Smooth, Sharp and Attention Grabbing Look that speaks volumes about its owner. The two-stage Matte Black Powder Coat Finish features a 5yr, limited warranty that ensures its durability and appealing look.
Specifications
PEOPLE WHO VIEWED THIS ITEM ALSO VIEWED
REVIEWS & CUSTOMER MEDIA
First, I have to brag.........I, a 5' 5", 140 lb. female, put this 105 lb bumper on by myself!! My husband was at work, so I thought what the heck, I'll give it a try. This is a well made, heavy bumper. As stated in other reviews, a couple of the holes in the hitch plate do not line up properly, even after drilling out holes as directed in instructions. I was able to get 2 out of the 4 to work. Then went to the hardware store and bought 2 that are slightly smaller in diameter. I recommend thoroughly drilling the holes out, even bigger than the 1/2". Since I was working by myself and had to stop to think things through and get creative with how to hold the thing, it took me approximately 4 hours. Which, I don't think is actually bad at all considering. The bumper was very well packaged. I am happy with the look.