Dana Ultimate D44 Front AdvanTEK Axle Assembly w/ 5.13 Ratio - ELD

QUESTIONS & ANSWERS

• Q: e locker to rubicon switch  cschwartz5 years ago

  Is there an adapter available to make this work with the rubicon factory locker switch?
• • 0 of 0 people found the following answer helpful

    A:  No, there is not.

    Northridge Kaleb @ Northridge4x4 5 years ago  
    Yes  No
    Was this answer helpful?

• Q: Locker Pin Connector Type  Nate5 years ago

  Does the E-Locker have a factory four or two pin connector? Thanks
• • 1 of 1 people found the following answer helpful

    A:  It is a 2 pin connector.

    Northridge Kaleb @ Northridge4x4 5 years ago  
    Yes  No
    Was this answer helpful?
  • 1 of 1 people found the following answer helpful

    A:  The Dana Ultimate 44 Advantek that I received has a 4 pin connector, which is the same as factory. However, the factor rubicon locker switch will not work unless you use the JL Tazer OEM harness.

    aneiford @
    Yes  No
    Was this answer helpful?

• Q: Jpp dana 44 adventek   Luv az rks6 years ago

  I just want to verify this axle is solid both sides? No FAD built in?
• • 0 of 0 people found the following answer helpful

    A:  Correct, there is no FAD in the Ultimate 44 JL axles.

    Northridge Kaleb @ Northridge4x4 6 years ago  
    Yes  No
    Was this answer helpful?